Don’t get caught in the Snow!


 

Will it snow this Christmas? My five year old doesn’t remember the last snow he’s played in…but he was only 18 months old then! And I certainly remember the snowfall we had when I pregnant and getting stuck for hours on a train up to Manchester.

Regardless of the joys and trials that real snow brings, it will always make a very cute Christmas card! This design uses three different snowflake stamps and a little heart thrown in for good measure!

If you’re following me on Instagram you may have seen my high speed videos of snowflake stamping! I start making this card with an A4 sheet of white card…cover it with snowflakes and then cut it up into 10 rectangles – each one unique!

To make the white snowflakes (can you spot them? One on the Kraft card and one on red) I have used a clear ink and white embossing powder. Once the snowflake is stamped onto the card, I quickly (needs to be wet) sprinkle on the embossing powder. Using my heat gun (basically a small, angry hairdryer!)  I heat the powder until it melts and sets a glistening snowflake. All seems so simple? Well, there are a few mishaps that happen along the way- here are my tips on how to avoid them!

My favourite Design Details

– The uneven border of red card- the gap is larger at the top and bottom and thinner at the sides. This is why I often refer to this card as the ‘Snowflake Banner’ design. It adds a nice bit of interest to the eye rather than the standard equal boarder.

– The combinations of only three colours for the snowflakes but it has white on red, brown on white, red on brown, red on white and brown on white. Now mathematically…there must be 6 options in total…which one am I missing?

– Each of these cards are different as the placement of the snowflakes depends on the background and how they’ve been cut. What I aim to do is position the snowflakes so that they are overlapping one another and spread across the banner – overhanging onto the Kraft card.

Kit details

Beginner’s Kit contains everything to make 4 cards and each piece of card (background, mounts, greeting and the snowflakes) are cut to size and edged with the matching red ink. Decide how to position everything and the stick it all together! Foam pads are included so you can chose to raise some of the snowflakes up.

The Advanced Kit is a bit more technical, full instructions are included but in short you get to cut round each of the snowflakes and use the ink pad and dabber (included in the kit) to add the hazy red edge to the greeting, background and the snowflakes. Feel free to experiment and send me a picture of the results!

Got it! I’m missing brown on red! Maybe I’ll include that for Christmas 2017!

Leave a comment

Your email address will not be published. Required fields are marked *