Are you ready to embark on a creative journey into the world of stamping? Whether you’re a novice to stamping or you tried it in the past but never succeeded, this blog post will guide you through the process. Lots of tips and tricks to make your stamping projects a breeze.


1. Preparing Your Stamps
Choose which stamp you’d like to use, peel it away from the sheet and attach it to an acrylic block. They will cling to the block without any glue and can be returned to the sheet after you’ve used them.
If possible, use an acrylic block that is only slightly larger than the stamps – this will avoid the block rocking and blurring the edge of the stamp.

2. Inking your Stamps
I would recommend opting for a dye-based ink like Memento to give a crisp image and avoid bleeding with alcohol markers. Hold the ink pad and gently press it onto the stamp in a tapping motion to cover the whole stamp. Rremember to ink the stamp, don’t stamp the ink!
Take a few trial stamps on a piece of scrap paper to gauge pressure before moving to your main project. If the stamps are brand new, you may need to stamp onto scrap paper a few times before the ink fully clings to the stamp.
Most of my designs use black ink to stamp these images but you can use coloured ink instead – Memento Inks have a wide range of colours available. The possibilities are endless, and the results can be a fantastic addition to your paper crafting.

3. Let’s Stamp!
Pick up the acrylic block (carefully avoiding the ink) and turn it upside down and lower it over where you’d like to stamp. You’ll be able to see through the clear acrylic block and the clear stamp so you can know exactly where it will land. Press the stamp firmly onto the page and push down evenly on the back. Hold the paper in place and lift up the stamp upwards.
The Memento ink will dry in under a minute on normal card stock or paper. Test out your ink and card combination with some scrap pieces and once the test ones are dry to touch, you can can be certain your project will be.

4. Stamp Cleaning and Storage
Make sure you clean your stamps after each use (or change in ink colour) to maintain their quality. Pad them onto wet wipe to get rid of most of the ink and then use the wet wipe to get into any hard to reach areas on the stamp. Make sure the block is clean too as you can easily end up with inky fingers. Test the stamp on some scrap paper and it doesn’t leave a mark, peel it off from the block and return it to the acetate sheet.
Store your stamps flat and out of direct sunlight. If you’re using embossing powders or glitter on your projects, you might find the stamps become less sticky as fine powder particles stick to the stamps instead. They can be rescued – simply wash them in warm, soapy water and let them air dry. Lay them out and turn them over during drying to ensure thorough drying. They will then be sticky again!

Have fun!
Stamping is a delightful craft that is so versatile and the stamps will last for you. So, gather your supplies and start stamping your own creative projects.